Causes and Analysis of Aluminum Profiles-WJW Aluminum Supplier Aluminum Industry
Aluminum window manufacturers are known for producing high-quality and durable windows for residential and commercial buildings. These manufacturers use high-grade materials, advanced technology, and innovative designs to offer windows that not only provide exceptional performance but also enhance the aesthetics of any construction project. In addition to manufacturing, these companies also offer installation services to ensure that the windows are properly installed for maximum efficiency.
On the other hand, blog-intros are short introductions that capture the attention of readers and entice them to read further. These intros can be in the form of intriguing questions, catchy headlines or engaging stories. An effective blog-intro can create a lasting impression on the reader and encourage them to share the article with others. Therefore, it is important to create compelling intro to hook the readers and encourage them to continue reading.
Author： WJW Aluminum Window Manufacturers
Reasons for crispy aluminum profile 1. Lack of mold head pressure. The pressure at the mold is the tightening ratio of the mold, especially the length of the mold's straight section. The tightening ratio of the mold is too small or the straight section is too short. 2. The ingredients are unevenly produced, and the thickness of the material wall is not different, or the denseness is not different. This also forms the difference between the mechanical properties between the two places of the profile. As for the non -standard profiles such as the wall, it will not be said here. 3. The design of the section of the mouth mold is unreasonable, especially the spread of the inner tendons and the disposal of the angle of borders. This will form a stress concentration. The demand -improved design and the right angles and sharp corners of the soil surface. 4. The cooling rate of the setting mold. The cooling water temperature often does not attract enough attention. The role of cooling water is to cool the large molecular chain of the profile in time to cool down in time to reach the purpose of application. 5. Regarding the performance of the performance formed by the poor set of tendons, the length of the tendon and surface surface, tendon and tendons should be properly increased, or the tightening ratio should be increased.
The modification of the mold head pressure can be adjusted through the length of the mold head to adjust the resistance resistance; in the mold design stage, you can choose a different tightening ratio to change the extrusion pressure, but you must pay attention to the tight ratio of the head of the machine. The tightening ratio is in response to; it can also be modified to adjust the squeezing process parameters, and increase the porous board to change the melt pressure.
