Author: WJW Aluminum Window Manufacturers
Improper treatment of glass curtain wall nodes and closes will cause the firmness of the engineering structure to land, which will affect the quality and insurance of the curtain wall project. If the doors and windows and curtain walls have a panel and support structure system (supporting device and support system), it can have a certain displacement ability or a certain deformation capability compared to the main structure of the main structure. The curtain wall consists of a structural frame and inlaid board, and the building enclosure structure that does not bear the main structure load and function of the main structure. Wall plate node. For different wall plates, the nodes are treated with different nodes. Usually, the seams of the node are easily presented to the uneven edges or the surface of the plate is not the same. Determine the position of the other side device vertically. After both sides of the board reaches the request, tighten the bolt again and seal the glue. Corner area treatment. Usually use 1 straight -angle aluminum alloy (steel, stainless steel) board, directly connect to the outer wall plate with bolts, or fix it with angle force. Different data transfer. Usually at the part with horizontal and vertical materials, it should be fixed first, and then the stereotypes are connected to the rest of the lipstick, and a rubber pad or a dense sealing seal at the height (or left and right) plates of the lubble board (or left and right). The upper part of the daughter's wall and the window sills are all over the top treatment of the horizontal parts, that is, the metal plate is covered with a metal plate to prevent the wind and rain soaked. The horizontal cover is fixed. Individuals fix the firmware on the grassroots, and then use bolts to connect the cover with the skeleton, and properly leave the sewing and seal. Close at the edge of the wall. If the doors and windows and curtain walls have a panel and support structure system (supporting device and support system), it can have a certain displacement ability or a certain deformation capability compared to the main structure of the main structure. It is covered with metal or plate end and keel parts. Treatment of the lower end of the wall. Usually 1 special water shielding board is used to seal the lower end, and at the same time cover the gap between the board and the wall to avoid the rain soaked in the room. The guidelines for the processing of deformed seams should first be satisfied with the need to expand and settle down, and at the same time, it should also achieve the consequences of decoration. In addition, this part is a weak link of waterproof, and its structure point should be thoughtful. At first, there were such products produced by professional manufacturers, that is, to ensure its utilization function, and to satisfy the decoration requests. Usually, the system of alien metal plates and chloropyramlages was adopted.