How to Accept Doors and Windows Construction Technology-WJW Aluminum Supplier Aluminum

The doors and windows are connected to each room and the channel with the outside world, so the quality of the doors and windows is particularly important. When the doors and windows are device, it is necessary to accept the acceptance and the problem of invented the problem and repair it in a timely manner. So how to install doors and windows? How to accept doors and windows devices? Here. Preparation of doors and windows engineering construction technology permanent fixed window frame school booking fixed window frame passing the bubble (before the inner wall plaster) device fan and hardware tightly seal (before the glass before the glass) device glass glass The key technique of the window frame device requests the model room (two units symmetrical) on one of the units on the top floor of the building. Promoting: Understand the bidding documents and subcontracting contracts, understand the actual measurement of the window hole at the site before the window manufacturing, and then create it to avoid future disputes in the drawing stage of the drawing. Concrete to the edge so that the window frame device window hole (is a different type and a canther structure) in the future adopts rigid finished templates to reduce the differential deviation of the window hole. Larger biased windows hole window frame device pops up the horizontal line per layer of the balcony window, and the height of the horizontal line is 10cm at the bottom of the window hole. When the window frame is device, the inside of the concrete bar is the standard. After the device is implemented, the window frame is suspended in the part, and the measuring reinforcement is increased during the plastering construction. The doors and windows installation methods Wet the doors and windows frame device inlet deviations are greater than 10mm and the cavity entrance is trimmed after cement mortar trimming. Nylon expansion screws should be adopted. Wet combination window Following material 1. The high and low ports of the pupae should be blocked; The two -way tightening, the spacing should not be greater than 400mm; the distance from the two ends should not be more than 180mm; the gap between the patchwork door (window) frame should be sealing should be used for sealing treatment. Dry method door and window frame device 1. The gap between the main and auxiliary box device should be strictly controlled in strict according to the main auxiliary frame design gap. The actual gap of the main and auxiliary frame after the device should not be less than 4mm. 2. The main and auxiliary frame gap should be adjusted by the dedicated main auxiliary box gap. You must not use the fastener to fasten the handle of the main and auxiliary frame gap. How to accept doors and windows devices? 1. Check the verticality of the vertical horizontal level and window frame of the doors and windows frames. It is best to measure the horizontal ruler at the horizontal ruler. It may also be used as a hammer. The doors and windows should be less than 2 mm in height. 3 mm; the horizontal degree of the doors and window frames is best measured at the horizontal ruler, or it can also be used to fall into the road and window frame. If the water surface persists on a horizontal line to indicate the level of the door and window frame; The long water pipe is tested to see if the two real water levels are leveling. 2. Check the quality of the glass device, the glass should be flat, freckles without freckles, and waterless patterns; the nominal surface of the double -layer glass should be cleaned. There must be no dust and water in the glass expansion. The pressure bars with dense sealing must be tightly attached to the glass. There is no obvious gap at the joints of the press and the profile. The gap at the joints should be less than or or 1 mm. 3. Check the thoughtfulness of the thoughtfulness of the door and the fan page and the fan page of the fan. When the doors and windows are closed, there should be no obvious gap between the fan and the frame, and the sealing bar on the cover should be in a tightening condition. The above is the door and window construction technology shared with you, and how the doors and windows devices are accepted. I hope it can be helpful to everyone.