Introduction to the Processing Process of Industrial Aluminum Profiles! -Ruminum Profiles Supplier

Industrial aluminum profiles (also known as industrial aluminum pinching materials, industrial aluminum profiles) are aluminum materials with hot melting aluminum rods and obtained different section shapes. Unlike the parts of other alloy materials, the mechanical performance and application of industrial aluminum profiles produced The fields will also be different. Industrial aluminum profiles are widely used, so what steps are included in the processing process? Industrial aluminum profile processing process; 1. Based on on -site surveys, the preparation of structural analysis and design industrial aluminum profile processing must be scientifically and reasonably analyzed in the preparation of industrial aluminum profile processing. Do a good job of analysis to avoid unnecessary adverse effects caused by the initial omissions in construction or use in the later period; combined with the connection method must perform structural analysis at the same time, combined with the scientific and reasonable selection of the connection method of industrial aluminum accessories, ensure the beauty of the overall effect and the overall effect. Practical.

2. The technical personnel should be measured according to the scalar ruler measurement. The technical personnel shall draw the structural diagram based on the overall planning of the construction site, and then estimate the loss of all data based on the drawings to ensure the cost of saving. Only when they are good, do the measurement of all scale to ensure the accuracy of the later cutting.

3. Make an accurate incision (the incision can be divided into right -angle incisions and different view -point incisions) to accurately cut industrial aluminum profiles according to the drawings and scale data. During the cutting process The weak structure; the cutting of industrial aluminum profiles must use accurate cut saws to ensure the accurate size of the profile.

4. Analyze the connection according to the structure and different attachments. Based on the solidity and adhesion of different structures and structures, select the adhesive slices of different structures for bonding to ensure the beauty and practicality of the structure of the structure, the scope and scope of the structure and the structure of the structure. Strong, avoid unnecessary adverse effects in the later period.

5. Follow the components to start assembly to assemble the drawings according to the structure structure structure, which can achieve the effect of fast installation, save a lot of working hours and manpower, and reduce capital investment.