Author: WJW Aluminum Window Manufacturers
In modern family life, sliding doors and windows and plastic steel doors and windows have been widely used in buildings, which are both beautiful and convenient. It is necessary to understand the construction process of sliding doors and windows and the construction plan of plastic steel doors and windows. In this way, when decorating houses and receiving houses, it can also prevent unqualified construction problems.
1. The construction process of sliding doors and windows sliding doors and windows refer to the doors and windows in the upper part of the doors and windows, and the lower part is the sliding mouth of the guide rail. The materials including wooden doors and windows, aluminum alloy doors and windows, plastic steel doors and windows, and aluminum bag doors and windows are different, but the construction process is the same. The installation steps for sliding doors and windows are as follows:
(1) Determine the installation position: When the baseline is found, when the installation door is installed, the upper beam, side frame board and lower guide rail are determined according to the 500 mm horizontal line and coordinate reference line. Use screws to fix the upper beam on the top of the door opening.
If there is a side frame board, use a screw to fix the side frame board on the side of the opening wall.
(2) Fixed: The fixed position of the doors and windows removes the bolt and nuts on the hanging rack, puts them on the Iron Slender rail, and then use the screw to fix the type I steel slide rail to the bottom of the upper beam. Fix the lower guide rail with expansion bolts or plastic expansion tube screws.
(3) Installation method: When fixed pendant or track is installed, please install the suspension bolts into the special hole on the top of the door fan. Use wooden molds to slide the door along the guide rail, and then use a nut to fix the suspension bolt and pendant. Or fix the slide rail on the ground with screws.
(4) Inspection: Forced inspections are often under pressure during use.
If you want to make it durable, every step in the process of installation and structure must be in place. After installation, check whether the edge of the door and the side frame board match, fix the door gear and install.
2. Key points for the construction plan of plastic steel doors and windows
(1) Treatment of the gap between the frame and the wall: Due to the large expansion coefficient of plastic, a certain width gap is left between the plastic steel door and window frame and the wall to adapt to the safety of plastic expansion and contraction. The gap between the frame and the wall should be filled with foam plastic strips or oil felt rolls. Filling should not be too tight, so as not to deform the framework. The internal and external seams around the window frame are closely filled with sealing materials. You can also use silicone rubber sewing instead of cement mortar. No matter what kind of filling method is used, you need to pay attention to the following two points: First, filling and sealing materials should be able to withstand the relative movement between the wall and the frame and maintain the sealing performance. Second, plastic windows should not be filled and sealing materials. The framework has corrosion and softening. The asphalt material may soften the plastic, so it is not suitable for use.
(2) When installing the hardware accessories of plastic steel doors and windows, you must first drill on the pole, and then tighten it with a self -attack screw. It is strictly forbidden to nail the hammer directly on the nail.
(3) After cleaning the window frame of the window frame, the window frame should be temporarily removed and the number is stored separately. When the paint window is opened, the surface of the window should be protected by stickers.
If the frame fan is covered with slurry during the paint, it should be wiped with a soft cloth immediately. Do not scrape it with a metal tool. After painting, you should clearly remove the slag in the glass concave. So far, with the fierce market competition and the continuous development of various materials and new products, the latest statistics show that plastic steel doors and windows on the European market can account for 70 % of 15 % wooden windows and 15 % aluminum windows. This is about market share. It can be seen that the application of plastic steel doors and windows is widely used.
Through the above introduction, I believe you have learned about the construction plan of plastic steel doors and windows and the construction process of sliding doors and windows.